Ah (Ampere Hour) is the measurement of the battery capacity or the amount of energy that can be stored in a battery. Ah is important for applications that require a constant supply of energy over a period of time. Ah is measured in values of C such as C1, C5, C10, C20 and C100. The most common measurement is C20 for most batteries. These figures display the batteries capacity over a period of time for example a 100ah C20 battery can provide 100ah over 20 hours equal to 5ah per hour.

RC (Reserve Capacity) is a rating based on minutes rather than hours. The RC of a battery is the time it can maintain a supply for 25amps in minutes at a temperature of +25°C. Most manufacturers provide RC at a rate of 25amps.

Ah (Ampere Hour) is the measurement of the battery capacity or the amount of energy that can be stored in a battery. Ah is important for applications that require a constant supply of energy over a period of time. Ah is measured in values of C such as C1, C5, C10, C20 and C100. The most common measurement is C20 for most batteries. These figures display the batteries capacity over a period of time for example a 100ah C20 battery can provide 100ah over 20 hours equal to 5ah per hour.Some Lead Acid Batteries contain an additive of calcium which is a hardening agent within the plate grids which decreases water loss and increases electrical performance, shelf and service life.

A Lead Carbon battery is the replacement of the active material of the negative plate by a lead carbon composite which decreases sulfation and enhances charge acceptance of the negative plate.

A battery cycle is the discharge and recharge of a battery. This is mainly applicable for Leisure, Marine and Industrial batteries which require a deep discharge and recharge multiple times across service life. These batteries require different technology and chemistry to that of a standard starter battery but are still of a lead acid construction.

DOD (depth of discharge) is the measure of how a battery will perform at a specific level of discharge. If a battery battery is discharged 30% its DOD is 30%. The deeper the discharge on a battery the greater the effect to service life. For application purposes it is important to know the DOD and the conditions it has been tested under. The DOD gives further insight into the number of cycles possible at a certain DOD.

ECM (Enhanced Cyclic Mat) these batteries have tin plus have a double layer separator to increase service life. It also has an increased amount of electrolyte in the battery and thicker plates to improve cyclic performance.

AGM (Absorbed Glass Mat) is a technology that uses the absorbed glass material separators to hold the acid to the plates. This product is spill and leak proof as acid is held in the absorbent glass mat. AGM batteries often include Gas Recombination technology to retain the hydrogen and oxygen.

Gel batteries are a technology that suspends the electrolyte in an immobilised electrolyte and fumed silica substance. This was developed in order to create a spill proof battery when damaged or dropped. Often Gel batteries are recognised as deep cycle but a large factor in the effectiveness is down to the construction of the plates.

TPPL (Thin Plate Pure Lead) is a technology developed with a 99.99% pure virgin lead not alloy. The lead is rolled into thinner plates to allow more plates to be added to the battery creating a greater surface area. Batteries like Odyssey and NorthStar can produce a higher CCA than conventional batteries even at significantly lower temperatures.